Select Language
Currency Selection
  • Classic Five-Neck Ground-Joint Glass Electrochemical Cell

Classic Five-Neck Ground-Joint Glass Electrochemical Cell

Product code : LM-EC-CELL-5N         Comments (0)        Add Comment
Marka :  LabMateryal
Volume
5-20 mL (Conical Bottom) 25 mL 50 mL 100 mL 150 mL 250 mL 500 mL 1000 mL
-
+

The classic five-neck cell is the traditional electrochemistry setup with ground-glass necks and an inverted-cone lid. The set consists of the cell body, an F-type gas inlet tube, a salt bridge, a liquid seal and PTFE stoppers (manufacturer data).

The salt bridge brings the reference electrode close to the working electrode and reduces resistance in the measurement. The F-type inlet can feed gas both below and above the liquid surface: gas is bubbled through the solution before the measurement to remove oxygen, and only fed over the surface during the measurement. The 5-20 mL option has a conical bottom, so the solution amount can be adjusted for small samples.

The cell has standard sealing. When used with a rotating disk electrode (RDE), the shaft passage cannot be closed completely; increase the gas flow over the surface in this case.

The body is made of borosilicate glass 3.3, which has low thermal expansion (3.3 × 10⁻⁶ K⁻¹) and the highest resistance classes against water (HGB 1) and acids (S 1). Avoid sudden temperature differences above 120 °C to reduce the risk of breakage.

The single-layer body is a simple, economical choice for routine measurements at room temperature. If temperature control is needed, choose the jacketed version of the same cell.

Key Features

  • Five ground-glass necks and inverted-cone lid
  • F-type gas inlet, salt bridge, liquid seal and PTFE stoppers included
  • O-ring sealing screws on electrode feedthroughs
  • Eight volumes including a 5-20 mL conical-bottom option
  • Suitable for rotating disk electrode (RDE) measurements

Technical Specifications

Cell type Single chamber, standard-sealed, ground-glass necks
Temperature control None (jacketed version available as a separate product)
Body Borosilicate glass 3.3
Set contents Body, F-type gas inlet, salt bridge, liquid seal, PTFE stoppers
Sealing Ground neck + inverted-cone lid; O-ring screws for electrodes
Electrodes Long type required
Volume options 5-20 mL (Conical Bottom), 25 mL, 50 mL, 100 mL, 150 mL, 250 mL, 500 mL, 1000 mL
Not included Electrodes (sold separately)

Electrodes and membranes shown in the photos are for illustration only and are not included in the price. Compatible reference, counter and working electrodes and membranes are available in the Electrodes category of our site.

For volumes, dimensions or port layouts other than those listed, you can request a custom-made quotation through the Quotation Form.

Applications

  • ORR, OER and HER measurements with RDE/RRDE
  • CV and LSV under oxygen-free conditions
  • Electrocatalyst activity and stability tests
  • Classic three-electrode setup for teaching labs
★
★
★
★
★
Total 0 Comment made


Thank you for your comment. Your comment will be published after it is done.
Comment on you
Verification Code


Thank you for your question. You will be notified by email once your question has been answered.
Click to Ask a Question
  No questions have been asked for this product yet.
E-Newsletter
Do you want to be informed first about discounted products and opportunities?
softtr® | Profesyonel E-Ticaret Sistemleri ile hazırlanmıştır.